水草情迷

Recommended Maximum Aquarium: 40 U.S.g. (200 l)


Hagen網上資料, 富華204只建議適合200l或以下缸, 你4呎魚缸...

... 可能真係有問題都唔定 !

有關系的嗎?不是同樣在每小時出水量都和濾桶本身標準出水量一樣嗎?
無論缸是400L,300L,200L,水,濾桶都是出回它本身能力上之出水量嗎?
請多多指教.謝謝.

根本係新款d膠有問題!!!

如果我再次買多一個濾桶,什麼可靠性較高呢,E記除外.

佢d膠係好似比較軟身, 都好難講 !

總之我個104就好地地用到現在,
不過見你地咁樣, 下次我都唔敢再買... 有心理壓力...

水壓唔同丫嗎... 即假如個桶頂到200l水壓唔滲水, 但400l就未必可以

咁佢地應係說明書寫明la, 我寫過email問富華外國代理, 佢地答如下:
Dear Sir,

We are sorry to hear about the leaking motor head.

We are aware of a run of filter heads and cases that
were improperly molded and as a result fine hairline
cracks can appear and over time expand and cause
a slow leakage.

This is of course totally unacceptable and our HK
partner will take care of this without delay.

They can be contacted via e-mail above.

Also their address is as follows:

International Aquarium Supply Co.
Flat B to D, 12/F, Wu Lee Industrial Centre,
Block 1, No 30 – 38 Tsuen Wan,
New Territory, Hong Kong
Phone: 852-2409-8053
Fax: 852-2409-2541

e-mail: hkaquarium@hongkong.com


我想應該唔係水壓問題, 我150L水用404都爆! 應該係桶身d膠太硬, 我換過2次都發現d膠硬度同我之前爆果隻一樣, 而我換桶當日在代理那裹見到有很多等換不同大細的富華桶, 你話我換完重敢唔咁用la!! 後來自己在生龍配了隻舊款桶($130), 發現d膠無咁硬有彈性, 質地和桶蓋d膠一樣, 之後就未再爆過!! 如果大家用緊新款富華桶(有水閘控制出入水)我提醒大家check一check桶身和桶蓋d膠的質地係未一樣, 如果一樣就應該好安全, 否則最好時不時check下有無漏水!!


肥魚仔: 如果你的桶身d膠比較軟, 我想應該係無水閘果隻, 一定唔會咁易爆!

咁佢地應係說明書寫明la, 我寫過email問富華外國代理, 佢地答如下:
Dear Sir,

We are sorry to hear about the leaking motor head.

We are aware of a run of filter heads and cases that
were improperly molded and as a result fine hairline
cracks can appear and over time expand and cause
a slow leakage.

This is of course totally unacceptable and our HK
partner will take care of this without delay.

They can be contacted via e-mail above.

Also their address is as follows:

International Aquarium Supply Co.
Flat B to D, 12/F, Wu Lee Industrial Centre,
Block 1, No 30 – 38 Tsuen Wan,
New Territory, Hong Kong
Phone: 852-2409-8053
Fax: 852-2409-2541

e-mail: hkaquarium@hongkong.com


我想應該唔係水壓問題, 我150L水用404都爆! 應該係桶身d膠太硬, 我換過2次都發現d膠硬度同我之前爆果隻一樣, 而我換桶當日在代理那裹見到有很多等換不同大細的富華桶, 你話我換完重敢唔咁用la!! 後來自己在生龍配了隻舊款桶($130), 發現d膠無咁硬有彈性, 質地和桶蓋d膠一樣, 之後就未再爆過!! 如果大家用緊新款富華桶(有水閘控制出入水)我提醒大家check一check桶身和桶蓋d膠的質地係未一樣, 如果一樣就應該好安全, 否則最好時不時check下有無漏水!!


肥魚仔: 如果你的桶身d膠比較軟, 我想應該係無水閘果隻, 一定唔會咁易爆!

奇怪! d膠係比較軟, 但係有水閘wor, 個水閘係摃干式, 係出入水兩個一同open or close ...

咁會唔會係水貨呢？　請問桶身和桶蓋ｄ膠質係未一樣？　請問你隻桶在挪挪那裡買？　我的在川河買的。

當然一樣啦, 我反而覺得唔一樣才是有問題 ...

在大寶蕉買的...

聽代理說好像無水貨播...

各位魚友,我的204修理回來了,不知道會否和 fai 兄一樣再漏過,如果再漏....... 不過由上到代理至拿回濾桶只用了30份鐘,但我同樣見到很多404,204,等待修理,的確幾多吓.富記濾桶的品質........大家心中有数,我日後如要加器材的話.富記..............

你換回來的桶身和桶蓋所用的膠質是否一樣? 我用左1星期倒, 就發現桶身內再出現很多細烈紋, 一停濾桶餵魚就漏水...

肥魚仔: 代理都同我講富華在香港沒有水貨....可能大細桶用料不同???

FAI 兄:
桶蓋和桶身膠料一樣,希望吾再漏啦,但我細看下發現桶蓋和桶身都不是我送交修理的那個桶.哈哈.

希望你無事la