[問題]請問金霸桶出水位的水位是否不能高過拍定高度

nfish · **發表於 :** 2003-06-04 00:00

請問金霸桶出水位的水位是否不能高過拍定高度.如圖1.
另外,調低水制後,入水位的水位線同水平線一樣高,請問有冇問題.
如圖2.

ntlo · **註冊時間:** 2003-03-12 12:38 **文章:** 32

我反而好奇個出水口你點樣先可以整得咁高，依家為o左出水問題煩惱。

又，出水口位的器材是否可以DIY??

肥魚仔 · **發表於 :** 2003-06-04 18:43

nfish 寫:

請問金霸桶出水位的水位是否不能高過拍定高度.如圖1.

***應高過都無問題!

另外,調低水制後,入水位的水位線同水平線一樣高,請問有冇問題.
如圖2.

***代表水流量太慢lor...

nfish · **發表於 :** 2003-06-04 21:49

to: ntlo,
I have cut the tube, so the tube can higher than the water.
to: 肥魚仔
If I increase the flow, the flow is very big, all grass cannot stand straight, so I decrease the flow but the water level is too low. I afraid whether it will increase the workload of the filter.

肥魚仔 · **發表於 :** 2003-06-06 20:31

nfish 寫:

to: ntlo,
I have cut the tube, so the tube can higher than the water.
to: 肥魚仔
If I increase the flow, the flow is very big, all grass cannot stand straight, so I decrease the flow but the water level is too low. I afraid whether it will increase the workload of the filter.

I do think it will cause problem but don't too worry, many friends here do the same, so far seem no problem appear ...

nfish · **發表於 :** 2003-06-07 23:58

Thanks, 肥魚仔
I have changed to use of 雨淋管了,But I need to decrease the tube size of 富華by鋤仔. and drill more hole to decrease the flow. It is fine now. See pic :

http://www2.aqugrass.com/phpBB2/viewtop ... highlight=

However, I want to complaint the sales of 發x to advise me to buy a P20 instead of P10. And also the sales of x 浪to tell me the 富華雨淋管了is fit.

為了做成生意而不理客戶之利益之Sales不要得.

水草情迷

[問題]請問金霸桶出水位的水位是否不能高過拍定高度

誰在線上