水草情迷

本人用緊UP一L樽想 開多一個细缸CO2如何加多ㄧ個分位?

push

Not recommended. coz it's very difficult to control the volume of CO2 giving out to the two tanks.

_________________
24"x12"x14" w/ Eheim 2026+Arctica Mini
GLO T5HO 24Wx2
Lighting: 12:00pm-9:00pm
CO2: 2+ bubbles/sec
ADA Amazonia New

Thanks !
Fish Fan

Hi Tsangcf,
You can visit below web site to get some information for refer. By the way, some pepole make DIY for this component but you should search some compoents.

http://aqua.andy.tw/viewtopic.php?f=3&t=150814

我見到上下奇有CO2分插賣

As the Co2 is difficult to control the balanced pressure in both tank. therefore, you need a Co2 splitter (not the one for air-pump as the Co2 pressure is much much higher) with the controller to connect from the Co2 tank and then to both fish tank.

I have brought one in 水X店 at HK$250 and it works well last month. It is made in Japan.

Regards

在補充一下我個人的經驗好了,其實有很多水族用品,跟外面仿間生活或者工業用品示可以共通的,關於CO2的分接,我個人是去氣油壓五金行買一些零件回來組裝,跟之前提供給你的WEB SITE裡面的網友做法是一樣的,原則上,一個氣壓分歧塊,再加上幾個4/6管的節流閥,就可以搞定了,節流閥組裝至氣壓分歧塊需要纏上止洩膠帶(台灣有人會稱做TE-BU-SI-LU),然後組裝好之後,在接上電磁閥上的出氣口,記住"電磁閥上的微調開關要全開",這樣所有的氣體壓力才會轉換到氣壓分歧塊上,然後你就可以分別在各個節流閥上微調出氣大小,以上根本算不上是DIY,充其量只是將尋找到的零件,以工具個各組裝上而以,這個東西我之前做的總花費為,1出5氣壓分歧塊台幣50,3個節流閥台幣75,止洩膠帶台幣10塊,總共花費台幣135塊,跟水族館賣的台幣1000多差很多吧...

http://tw.myblog.yahoo.com/abo0412/arti ... =1#yartcmt

上面那個BLOG有詳細的做法,其實還有不少人是這樣做出來的,沒必要到水族館花那個冤枉錢吧...

Thanks every ching