水草情迷

hi all,
I just setup the CO2 system and my tank is upgrade.. : )

Pls give advice for my setting both hardware and the tank design : )thanks

hi 太陽草老人, for you suggestion, using 加Ｄ紅雨傘係中間重正!再唔係加紅柳係後面都得!, I have check that 紅雨傘 is quite expensive...... heheheh..... to me : )

if anyone have more 紅雨傘, if possible give me some ; )

http://www.pbase.com/kinthy

o.... first of all, many many thanks.....

well, l may send message to you for pickup the 紅雨傘 if you have free time later : )

thanks you very much : )

I really like your DIY water outlet. Can you give us more info about this ? thanks

thanks for the interesting in the DIY wateroutlet : )

for the DIY outlet, the idea is to replace the P20 water outlet ( nozzle)and the advantage is

1, the water current minimize on the tank floor which the bubble which generate from grass can be see clearly.
2, provide a wider playground for the fish to swim with the water current.
3, now my P20 valve can be fully open with the water output will be not too strong and too concentrate on one stream.

the steps are very simple.

1, find a tube which is with J shape.
2, drill holes around 4 mm each and 1" between, I have drill 9 holes.
3, connect the J tube and the rigid solid plastic tube with the soft rubber tube with 1.5 cm long.
4, at the end of the tube, cut a little rubber tube and wrap into spiral shape and put end of J tube which use to stop the water outout from the end of the tube.

ref:
http://www.pbase.com/image/12389878

Thank you very much nice and clear but Where can I find a J tube ?

The shop is beside "Car Kei" There is one more left on the side wall hanging on the wall. most of the parts are ehiem accessary....

hope u can find out there.

or you can use a straight tube and some 90 degree shape tube and connect them togather : )

DIY spirit : )