水草情迷

綜合水族資訊討論區
留言室 | 相片分享區 | 草圖-我的相簿
現在的時間是 2025-02-27 07:29

所有顯示的時間為 UTC + 8 小時




發表新文章 回覆主題  [ 28 篇文章 ]  前往頁數 12  下一頁
發表人 內容
未閱讀文章發表於 : 2002-11-18 11:28 
離線
頭像

註冊時間: 2001-10-10 08:00
文章: 1109
來自: 中國-香港特別行政區
有冇魚友以前或現在用過EHEIM的圓柱形濾桶?
我現在用緊EHEIM 2211的圓柱形濾桶﹐但有一個好麻煩的問題﹐每次洗完個濾桶後就要同佢鬥力﹐因為個頂部係好難蓋番﹐細力就蓋吾到﹐大力就驚弄爆個膠桶﹐大家有冇此經驗或有何高見?

http://www.eheim.com/Zubehoer.cgi?Mode= ... esamtliste


回頂端
 個人資料  
 
 文章主題 :
未閱讀文章發表於 : 2002-11-18 12:51 
離線

註冊時間: 2002-07-23 21:38
文章: 158
來自: 沙田
我都係用佢
你有冇開左個出水口水制呀
唔開緊係要同佢鬥力啦
開左佢 , 等佢 release 左 d pressure 出黎先得嫁


回頂端
 個人資料  
 
 文章主題 :
未閱讀文章發表於 : 2002-11-18 13:21 
離線
頭像

註冊時間: 2001-10-10 08:00
文章: 1109
來自: 中國-香港特別行政區
arki兄﹐
我當然有打開個出水口既水制﹐入水口既水制就一定係關上﹐不過都好難蓋番個頂泵呀!
我覺得係條黑色膠圈同我鬥緊力。
:h


回頂端
 個人資料  
 
 文章主題 :
未閱讀文章發表於 : 2002-11-18 13:23 
離線
頭像

註冊時間: 2001-11-24 08:00
文章: 271
我兩個閘制都開哂,然後先蓋番好佢,好易攪之麻!


回頂端
 個人資料  
 
 文章主題 :
未閱讀文章發表於 : 2002-11-18 13:27 
離線

註冊時間: 2002-10-29 00:54
文章: 50
If you open both 閘制, water pressure inside will be lost. Then you will have to do the sucking process over again. I normally open the 出水口閘制, and it works fine with me. I use 2213.


回頂端
 個人資料  
 
 文章主題 :
未閱讀文章發表於 : 2002-11-18 13:35 
離線
頭像

註冊時間: 2001-10-10 08:00
文章: 1109
來自: 中國-香港特別行政區
EHEIM 2211的入水口在桶的底部﹐如果開埋個入水口既水制﹐桶內大部份的水都會由入水口流番出來﹐到我蓋番個頂後又要花好多功夫先可以令水流順暢。
因為地方淺窄﹐個濾桶是放在魚缸旁邊﹐但魚缸水平線是高過濾桶個頂部﹐好困難先能另佢運行呀!
:h


回頂端
 個人資料  
 
 文章主題 :
未閱讀文章發表於 : 2002-11-18 14:06 
離線

註冊時間: 2002-10-29 00:54
文章: 50
nil,

2211 is the same as 2213. 2213 is a little bit bigger and has higher throughput. I have extractly the same setup as you. I put my filter at the same level as my tank and the height of the filter is higher than the top of my tank.
Do you have the Double-tap-connector? When I bought my 2213 2 years ago, it comes with the filter. Use these connectors will make your filter runs smoothly after you clean your filter.


回頂端
 個人資料  
 
 文章主題 :
未閱讀文章發表於 : 2002-11-18 14:18 
離線
頭像

註冊時間: 2001-10-10 08:00
文章: 1109
來自: 中國-香港特別行政區
redspot兄﹐
你是否指在出及入水喉的雙開關水閘制呀?
我在出水及入水口都有用呀!因為方便拆個桶出來清洗呀!
但你每次洗完桶駁番個濾桶後﹐有冇將個濾桶放在比魚缸低的位置﹐讓它運行暢順後先放回魚缸側呢?


回頂端
 個人資料  
 
 文章主題 :
未閱讀文章發表於 : 2002-11-18 14:24 
離線
管理員
頭像

註冊時間: 2001-08-28 08:00
文章: 12412
來自: 香港-屯門
係川x 見有款 eheim 的出/入水喉, 有個位置係比你灌水入個桶而唔駛用口吸水o既, 不過有點貴, 出/入水係分開買, 每套要成百四蚊.
即係呢件 (圖片來自 Eheim)
圖檔

_________________
多多交流, 多多研究, 多多搜尋
我的水族相簿


回頂端
 個人資料  
 
 文章主題 :
未閱讀文章發表於 : 2002-11-18 14:27 
離線

註冊時間: 2002-01-03 08:00
文章: 146
來自: fanling
eheim 跟筒應有一支油,把它搽在O'ring 上,這會易些。


回頂端
 個人資料  
 
 文章主題 :
未閱讀文章發表於 : 2002-11-18 14:31 
離線
頭像

註冊時間: 2001-10-10 08:00
文章: 1109
來自: 中國-香港特別行政區
ys兄﹐
我吾覺有枝咁既油呀!
有冇得買番枝呀?
可吾可以用「花士令」呢?
:j


回頂端
 個人資料  
 
 文章主題 :
未閱讀文章發表於 : 2002-11-18 14:37 
離線

註冊時間: 2002-10-29 00:54
文章: 50
nil, no. I did not put the filter below the tank for easy start. Here is what I did everytime.

1) close all 雙開關水閘制, switch off the filter.
2) disconnect the filter hoses and power.
3) open the output 水閘, open the top cover.
4) clean the filter with old water.
5) after done, fill the filter with water again.
6) lock all 4 top cover clips.
7) close the output 水閘.
8) put the filter back to same position.
9) connect all 雙開關水閘制, connect power.
10) switch on filter first, and then release 雙開關水閘制s.
11) water run smoothly again.

Hope these help.

And SuperCTW, yes. I seen these in fish street too. They are too expensive.
ys, that is vaseline. It comes with new model of Eheim filter. Old filter don't have it. I never use it although I have a lot of it. I am afraid it will get into the water and harm the plant and fish.


回頂端
 個人資料  
 
 文章主題 :
未閱讀文章發表於 : 2002-11-18 15:02 
離線

註冊時間: 2002-01-03 08:00
文章: 146
來自: fanling
redspot
I try it on my 2231 and it make me very easy to open and close the filter, It no any harm of my fish,
Nil
don't try 花士令, it casued your fish and plant dead.
superctw
your photo is the old model, the new one has a different, pls click the following to look
http://www.eheim.de/eheim/inhalte/engli ... p?id=20493


回頂端
 個人資料  
 
 文章主題 :
未閱讀文章發表於 : 2002-11-18 15:03 
離線
頭像

註冊時間: 2001-10-10 08:00
文章: 1109
來自: 中國-香港特別行政區
有冇魚友知道「花士令」(Vaseline)會否影響水質?
:j


回頂端
 個人資料  
 
 文章主題 :
未閱讀文章發表於 : 2002-11-18 15:10 
離線

註冊時間: 2002-10-28 17:17
文章: 30
可能是條o'ring 硬化,可到精明買過一條


回頂端
 個人資料  
 
顯示文章 :  排序  
發表新文章 回覆主題  [ 28 篇文章 ]  前往頁數 12  下一頁

所有顯示的時間為 UTC + 8 小時


誰在線上

正在瀏覽這個版面的使用者:沒有註冊會員


不能 在這個版面發表主題
不能 在這個版面回覆主題
不能 在這個版面編輯您的文章
不能 在這個版面刪除您的文章
不能 在這個版面上傳附加檔案

前往 :  
Powered by phpBB® Forum Software © phpBB Group
正體中文語系由 竹貓星球 維護製作