[問題] 如70"x24"HX22"W只用3XHQI夠嗎?

ALVINKK · **發表於 :** 2005-11-28 23:17

如70"x24"HX22"W只用3XHQI夠嗎?
自己计369L给450W光是OK,但會不會
有死位呢? 如要加PL 等?
而自己DIY HOIX3 约$1000,,ATMAN MG1500
约$2300,自己DIY是否也可?

草人 · **註冊時間:** 2003-03-28 09:43 **文章:** 4235

麻麻地夠.
又深又長又寬..
接近 6 呎呀, 話就話一支150W鹵仔可以照到 2呎範圍,
你個缸既呎吋到時就未必夠架啦.
DIY 就係 FIT 自己需要啦, 幾多支自己話事囉.

ALVINKK · **發表於 :** 2005-11-29 18:44

Andy Kong · **發表於 :** 2005-11-30 01:45

ATMAN 1500 is 3x150 HQI + 6x24W PL

If you go for DIY, I suggest you go for 3x150HQI + 6x36W PL

ALVINKK · **發表於 :** 2005-11-30 16:32

那4x150HQI,就OK了? 因怕PL去不到底,,THX

Andy Kong · **發表於 :** 2005-11-30 16:54

Different purpose. At 24" high, the HQI can cover the bottom alright because it has the height to 擴散, but you'll have gap or dar corner at the upper and middle part, so PL can cover that part better as PL as a much longer 發光 area when compare to HQI

ALVINKK · **發表於 :** 2005-12-02 00:17

Andy Kong 寫:

Different purpose. At 24" high, the HQI can cover the bottom alright because it has the height to 擴散, but you'll have gap or dar corner at the upper and middle part, so PL can cover that part better as PL as a much longer 發光 area when compare to HQI

我讀得書小,吾好笑我,可否用中文呢?^^

Andy Kong · **發表於 :** 2005-12-02 00:24

ALVINKK 寫:

我讀得書小,吾好笑我,可否用中文呢?^^

Sorry, my handwriting board was broken while I was travelling, so I can only use English for the moment, I am completely ignorant when come to Chinese Input Method
:oops:

ALVINKK · **發表於 :** 2005-12-02 05:14

OH,,IC,,那请間你公司的大缸,,COFFEESHOP, 170L 的滴瀘缸,幾錢左右,在那地方買呀?THX ^^

Andy Kong · **發表於 :** 2005-12-02 07:18

ALVINKK 寫:

OH,,IC,,那请間你公司的大缸,,COFFEESHOP, 170L 的滴瀘缸,幾錢左右,在那地方買呀?THX ^^

That was custom make with the 大缸 at the same time, I do not have a number for the 滴瀘缸 only, sorry.,

水草情迷

[問題] 如70"x24"HX22"W只用3XHQI夠嗎?

誰在線上