Hi all,
I have a question about water change, hope can have some advices! many many thks
Now I'm using
sand substrate.
Each time I do water change, my general work is to fill up a 40 Litre bucket (about 1/4 of total tank volume)with air pump & active carbon filtration, running over night. Before pour the new water into the tank at the next day, I will use chlorine remover and blackwater first. Ph tested after this treatment is just below a bit 7.0 which may suitable for my sand substrate since ph test to the tank almost shown about 7.0
But how about using
ADA mud ? As I known the ph should be well below 6.0, so does it requires some treatment to the new water in order to reduce that ph difference ??
P.S. I have
searched the old post but seems not found, may be I can only use english so no matching post ma....
if there were some old posts pls don't blame me